High-quality construction fasteners
Back to catalog

elementa EAF 350S

elementa
Bonded Anchor Based on Epoxyacrylate Resin elementa EAF 350S
APPOVALS AND CERTIFICATES
fcs opt7 r120 sto2020 cniisk
NSF eiler 100 лет Арматура
Use for
  • Non-cracked concrete of strength class C20/25 at minimum, solid stone, aircrete, сlaydite-concrete, masonry
  • Installation of noise screens, guardrails, electricity pylons, billboards, columns, beams, pillars, stairs, elevator guides, various equipment, rebar connections, ventilated facade substructures and glass facades
Advantages

  • Сartridge type elementa "Side by Side"
  • Styrene free
  • FAI «Federal Center of Standardization» Approval
  • Designed according to "Anchor Fastenings to Concrete. Design Rules.", 2020
  • Designed with eiler application
  • ETA Option 7 for non-cracked concrete
  • Seismic resistance tests «Central research Institute V. A. Kucherenko»
  • Fire resistance R120
  • Suitable for flooded and wet holes
  • For threated rods and rebars
  • Does not create stress in a base material
  • Minimum edge and spacing distance
  • Easy extrude resin from the cartridge
  • Multiple use system
  • Diamond drilled holes need more roughness
  • For indoors and outdoors applications

Application examples Installation procedure
Химия.Пробурить отверстие необходимого диаметра на требуемую глубину
1. Drill a hole of the required diameter to the required depth.
Химия прочистка
2. Blow out the hole twice from a drilling dust, perform the brushing twice and blow out twice again.
Химия. Заполнение
3. Extrude resin until the hole is approximately 2/3 full.
Химия.Установка шпильки
4. Install the threated rod in the hole and don’t disturb the anchor until the minimum cure time has elapsed.
Химия. Затягивание
5. Tighten the nut with recommended torque Tinst.
YOU PROBABLY ALSO NEED:
Cuttori catalogue.
Cuttori
More details